Lenco TAB-811 - Manual (Page 8)

8
Charging Battery
The device has a built-in rechargeable battery. No extra battery installation is required.
Just charge the device when it indicates low battery.
To charge the battery, connect the device to any standard wall outlet via the DC-IN
port using the power adaptor. It takes about 5 hours to fully charge the battery. When
the battery is fully charged, the charge indicator should light up in green. During
charging, the indicator lights up in red.
Note:
a. You are strongly recommended to charge the battery immediately when the device indicates the
battery is lower than 15%!
b. You can operate the device even when it is being charged. But for extended battery life, it is suggested
NOT to use the device when it is charging.
c. It is recommended to charge the battery before you use the device for the first time.
d. For maximum performance, lithium-ion batteries need to be used often. If you don’t use the device
often, be sure to recharge the battery at least once per month.
e. Be sure to use only the dedicated power adaptor provided with the unit for charging.
If at any time in the future you should need to dispose of this product please note that:
All batteries and accumulators need to be removed from this product (Removal of
Waste Batteries and Accumulators).
Use the following instructions to readily remove the batteries and/or accumulators:
1. Open the unit with a screwdriver
2. At the center of the unit you find 3 wires, red, white
and black. Cut them one by one.
IMPORTANT: Never cut the wires at the same time!
This could allow the battery to explode!
3. Place a screwdriver under the battery and remove it
from the main unit.
Batteries and accumulators need to be disposed
accourding to the Waste Electrical and Electronic
Equipment Directive.