Altera SoC Embedded Design Suite User Manual
Page 193
Table 9-1: HPS Flash Programmer Parameters
Option
Short
Option
Required
Description
--cable
-c
Yes
This option specifies what download cable to
use.
To obtain the list of programming cables, run
the command "jtagconfig". It will list the
available cables, like in the following example:
jtagconfig
1) USB-Blaster [USB-0]
2) USB-Blaster [USB-1]
3) USB-Blaster [USB-2]
The "-c" parameter can be the number of the
programming cable, or its name. The
following are valid examples for the above
case:
-c 1
-c "USB-Blaster [USB-2]"
--device
-d
Yes (if there are
multiple HPS
devices in the
chain)
This option specifies the index of the HPS
device. The tool will automatically detect the
chain and determine the position of the HPS
device; however, if there are multiple HPS
devices in the chain, the targeted device index
must be specified.
ug-1137
2014.12.15
HPS Flash Programmer
9-3
HPS Flash Programmer User Guide
Altera Corporation