Altera High-Speed Development Kit, Stratix GX Edition - Manual (Page 37)

Altera Corporation Quartus II Version 3.0 4–9
Run the Preloaded Diagnostic Tests Stratix GX HM-Zd SPI-4.2 Loopback
Figure 4–5. Install the HM-Zd SPI-4.2 Loopback Cards
4. Supply power to the board.
5. Confirm that the Stratix GX device has finished configuration (the
GX_CONF_DONE (D7) LED illuminates).
Run the Stratix GX HM-Zd SPI-4.2 Loopback Test
Perform the following steps to run the test.
1. Setthe Stratix GX dipswitch 5 to 1 (up position).
2. Press the reset pushbutton switch (GX_CLR).
3. Press the start pushbutton switch (Stratix_GX_PB_0). Several LEDs
illuminate.
● LED0 is the high-speed data match LED. If it illuminates, the test
is successful.
● LED1 indicates that the GX device has received the data.