Altera High-Speed Development Kit, Stratix GX Edition - Manual (Page 57)

Altera Corporation Quartus II Version 3.0 5–13
Perform the Production Diagnostic Tests Perform the Standard Tests
5. Although this design uses both the Stratix and Stratix GX devices,
the Stratix GX device controls it. Set all of the Stratix GX user
dipswitches to 0.
6. Press GX_CLR (S14) to reset the design. The GX_CLR (D16) LED
illuminates and the Stratix GX LEDs 0 through 4 (D10, D11, D12,
D13, and D14) should be off. Additionally, the Stratix LEDs 0 and 1
(D18 and D19) illuminate while the rest are off.
7. Press the start pushbutton switch (Stratix_GX_PB_0). Several LEDs
illuminate.
● Stratix GX LED0 is the match LED. If it illuminates, the test is
successful.
● Stratix GX LED1 indicates the test has started.
● Stratix GX LED2 indicates that the GX device is transmitting to
the Stratix device.
● Stratix GX LED3 indicates that the GX device has received the
data from the Stratix device.
● Stratix GX LED5 illuminates if there is an error.
8. Press the stop pushbutton switch (Stratix_GX_PB_1) to stop the
device from transmitting.
9. Press the reset pushbutton switch (GX_CLR).
10. Press the start pushbutton switch (Stratix_GX_PB_0).
11. Inject an error by pressing Stratix_GX_PB_2 (S4) once. The number
01 displays on the Stratix GX 7-segment display (D9) and Stratix GX
LED5 illuminates.
12. Inject two more errors by pressing S4 twice. 03 displays on the
Stratix GX 7-segment display (D9).
13. Press start and then reset three times to insure that the test is
working.
14. If all of these tests pass, write the word “PASS” in the column under
Stratix and Stratix GX in the row Stratix GX-to-Stratix Bridge in the
worksheet.