Towing the vehicle with the rear axle raised, Towing a vehicle with both axles on the ground, Transporting the vehicle – Mercedes-Benz 2013 E Class Coupe User Manual
Page 368: Breakdown assistance, Towing and tow-starting

Removing the towing eye
X
Unscrew and remove the towing eye.
X
Attach cover : to the bumper and press
until it engages.
X
Place the towing eye in the vehicle tool kit.
Towing the vehicle with the rear axle
raised
!
The ignition must be switched off if you
are towing the vehicle with the rear axle
raised. Intervention by ESP
®
could
otherwise damage the brake system.
Only possible for vehicles without
4MATIC.
X
Switch on the hazard warning lamps
(
X
Turn the SmartKey to position
0 in the
ignition lock and remove the SmartKey
from the ignition lock.
X
When leaving the vehicle, take the
SmartKey or the KEYLESS-GO key with you.
When towing your vehicle with the rear axle
raised, it is important that you observe the
safety instructions (
Towing a vehicle with both axles on
the ground
It is important that you observe the safety
instructions when towing away your vehicle
(
The automatic transmission automatically
shifts to position
P when you open the driver's
or front-passenger door or when you remove
the SmartKey from the ignition lock. In order
to ensure that the automatic transmission
stays in position
N when towing the vehicle,
you must observe the following points:
X
Make sure that the vehicle is stationary and
the SmartKey in the ignition lock is in
position
0.
X
Turn the SmartKey to position
2 in the
ignition lock.
On vehicles with KEYLESS-GO, use the
SmartKey instead of the Start/Stop button
(
X
Depress and hold the brake pedal.
X
Shift the automatic transmission to
position
N.
X
Release the brake pedal.
X
Release the parking brake.
X
Switch on the hazard warning lamps
(
X
Leave the SmartKey in position
2 in the
ignition lock.
i
When towing with the hazard warning
lamps switched on, use the combination
switch as usual to signal a change of
direction. In this case, only the turn signals
for the desired direction flash. After
resetting the combination switch, the
hazard warning lamps start flashing again.
Transporting the vehicle
!
You may only secure the vehicle by the
wheels, not by parts of the vehicle such as
axle or steering components. Otherwise,
the vehicle could be damaged.
The towing eye can be used to pull the vehicle
onto a trailer or transporter for transporting
purposes.
366
Towing and tow-starting
Breakdown assistance