Connecting a, Composite video, Source device” on – Optoma FX5200 User Manual
Page 22: Connecting a composite video source device
EN-22
Connecting a composite Video source device
Examine your Video source device to determine if it has a set of unused
composite Video output sockets available:
If so, you can continue with this procedure.
If not, you will need to reassess which method you can use to connect to
the device.
To connect the projector to a composite Video source device:
1. Take a Video cable and connect one end to the composite Video output
socket of the Video source device.
2. Connect the other end of the Video cable to the VIDEO socket on the
projector.
Important
If the selected video image is not displayed after the projector is
turned on and the correct video source has been selected, check that
the Video source device is turned on and operating correctly. Also
check that the signal cables have been connected correctly.
You need only connect to this device using a composite Video
connection if Component Video and S-Video inputs are unavailable
for use. See
“Connecting Video source devices” on page 19
for
details.