Optoma FX5200 - Manual (Page 33)

EN-33
Power mode (standby)
Set whether the VGA OUT function works when the projector is in standby
(powered off but connected to AC power).
„
Eco mode: The VGA OUT function will not work when the projector is in
standby.
„
Active mode: The VGA OUT and AUDIO OUT functions will work when
the projector is in standby.
Auto Power Off
Set the countdown timer interval. The countdown timer will start, when there
is no signal being sent to the projector. Then projector will automatically
power off when the countdown has finished (in minutes).
Quick Resume
If the projector is accidentally turned off, this feature allows the projector to
be instantly powered on again within 100 seconds of power down.
Source Lock
„ On: The projector will search specified connection port.
„ Off: The projector will search for other signals if the current input signal is
lost.
Brightness Mode
„ Bright: Choose “Bright” to increase the brightness.
„
Eco: Choose “Eco” to dim the projector lamp which will lower power
consumption and extend the lamp life by up to 120%.
„ Eco
+
: Choose “Eco
+
” to dim the projector lamp which will automatically
detect the brightness level of the content and reduce lamp power
consumption (up to 70 percent) during periods of inactivity.
High Altitude
Use this function to allow the fans operates at full speed continuously to
achieve proper high altitude cooling of the projector.
OSD Timeout
Duration of OSD menu display countly starts (at idle state by second).
Closed Captioning
Enable or disable closed captioning by selecting CC1,CC2 or Off.
Projector ID
ID definition can be set up by menu (range 0~99), and allow user control an
individual projector by RS232.
Network
Allow you to configure the LAN settings.
„ Network State:Display the network connection status.
„ DHCP: This protocol automatically assign IP Address to networked