Connect to 3d video devices, Installation – Optoma X402 User Manual
Page 13
13
English
Installation
Connect to 3D Video Devices
The 3D video
source device
must be
powered on
before the 3D
projector.
If input video
is normal 2D,
please press
“3D Format”
and switch to
“Auto”.
If “SBS Mode”
is active, 2D
video content
will not display
correctly.
Once you have connected your devices together with HDMI
cables, as shown in the diagram, you are ready to begin.
Power ON your 3D video source and your 3D projector.
PlayStation
®
3 Games
Make sure that you have updated your console to the latest soft-
y
ware version.
Go to the “Settings menu -> Display settings -> Video output ->
y
HDMI”. Select “Automatic” and follow the on-screen instructions.
Insert your 3D game disc. Alternatively you can download games
y
(and 3D updates) via the PlayStation
®
network.
Launch the game. In the in-game menu, select “Play in 3D”.
y
Blu-ray 3D™ Player
Make sure that your player can support 3D Blu-ray™ disc and that
y
3D output is enabled.
Insert the 3D Blu-ray™ disc into the player, press “Play”.
y
3D TV (e.g. SKY 3D, DirecTV)
Contact your TV service provider to enable any 3D channels on
y
your channel package.
Once enabled, switch to the 3D channel.
y
You should see two images side-by-side.
y
Switch to the “SBS Mode” of the 3D projector. The option is lo-
y
cated in the “Display” section of the projector OSD menu.
3D Device (e.g. 3D DV/DC) with 2D 1080i side by side signal
output
Connect your 3D device and switch to out 3D content with 2D
y
side-by-side output to 3D Projector.
You should see two images side-by-side.
-
Switch to the “SBS Mode” of the 3D projector. The option is lo-
y
cated in the “Display” section of the projector OSD menu.
If watching 3D content from an HDMI 1.4a source (e.g. 3D Blu-ray)
your 3D glasses should always be in sync. If watching 3D content
from an HDMI 1.3 source (e.g. 3D broadcast using SBS mode) it may
be necessary to use the projector’s 3D Sync-Invert option to optimize
your 3D experience. The option is located in the “Display ->3D” sec-
tion of the projector OSD menu.