Optoma X402 - Manual (Page 17)

17
English
Installation
Powering Off the Projector
1. Press the “ ” button on the remote control or on the Key-
pad to turn off the projector. The following message will be
displayed on the screen.
Power Off?
Press Power again
Press the “ ” button again to confirm otherwise the
message will disappear after 15 seconds. When you press
the “ ” button for the second time, the projector will display
countdown timer and will shut down.
2. The cooling fans continue to operate for about 10 seconds
for cooling cycle and the On/Standby LED will Flash
Green or Blue. When the On/Standby LED lights solid
Red, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and
has entered standby mode. Once in standby mode, simply
press “ ” button to restart the projector.
3. Disconnect the power cord from the electrical outlet and
the projector.
4. Do not turn on the projector immediately following a power
off procedure.