Applied Motion 2035 - Manual (Page 2)

Introduction
Thank you for selecting an Applied Motion Products motor control. We hope our
dedication to performance, quality and economy will make your motion control
project successful.
If there's anything we can do to improve our products or help you use them better,
please call or fax. We'd like to hear from you. Our phone number is (800) 525-
1609 or you can reach us by fax at (831) 761–6544.
Is This the Right Manual?
Technical Specifications
-15- -2-
Dual, bipolar H-bridge, pulse width modulated switching at 20kHz.
12-35 VDC input. 0.125 - 2.0 amps/phase output current, switch
selectable in 0.125 A increments. 70 watts maximum output power.
Automatic idle current reduction, reduces current to 50% of setting
after one second.
0 to 5000 steps per second. Linear acceleration and deceleration,
individually adjustable from 5 to 900 msec.
Step, direction and enable, optically isolated, 5-24V logic. 2200
ohms input impedance. Motor steps when STEP input turns off.
10 µsec minimum low pulse. 50 µsec minimum set up time for
direction signal. Step input is run/stop in oscillator mode. (0 =run,
1 = stop.)
Optically isolated. Uncommitted (open collector, open emitter)
phototransistor, 24V max, 20 mA max. One pulse per step.
Mounted on 1/4 inch thick black anodized aluminum heat transfer
chassis. 1.5 x 3.0 x 4.0 inches overall. Power on LED. See
drawing on back cover for more information. Maximum chassis
temperature: 70˚C. Weight: 9 ounces (250 g).
Ambient temp range (operating): 0 - 70˚C.
European style screw terminal blocks.
Power Supply: 2 position.
Motor: 4 position.
Signal Input: 4 position (2035), 9 position (2035 O)
Max wire size: AWG 16.
Amplifiers
Oscillator
(2035 O)
Inputs
Tach Output
(O suffix)
Physical
Connectors
This manual is for 2035 and 2035 O drives of revision level E. Earlier drives had
fewer features and different connections that revision E, so they require a different
User's Manual.
If this is the manual that was shipped with your drive, it's almost certainly the right
one. How can you tell for sure?
Hold the drive so that the words "Step Motor Driver" are at the bottom. On the right,
you'll see a blue screw terminal connector. How many terminals does it have?
3 terminals - old 2035 or 2035 O. This is the wrong manual.
4 terminals - new 2035. This is the right manual.
9 terminals - new 2035 O. Right manual.
If this is the wrong manual, call the factory and request the "old" 2035 manual.