Four .156" mounting holes – Applied Motion 1240i-485 User Manual
Page 16
Advertising
-16-
-17-
Mounting the Drive
The 1240i has four 0.156 inch diameter holes in the circuit board for mounting.
Always use standoffs or spacers to support the 1240i: a 1240i with power connected
will be damaged if you set it on a conductive surface without supports. The standoffs
or spacers can be up to 0.25 inch in outer diameter. You can use #4 or #6 screws to
fasten the 1240i.
Four .156" mounting holes
Advertising