Applied Motion 3540MO - Manual (Page 2)

-19-
Amplifiers
Inputs
Recommended
Joystick
Speed Ranges
Tach Output
Physical
Connectors
Microstepping
CE Mark
Dual, bipolar MOSFET H-bridge, pulse width modulated three
state switching at 20kHz. 12-42 VDC input. 0.4 - 3.5
amps/phase output current, switch selectable in 0.1 A
increments. 122 watts maximum output power. Automatic idle
current reduction (switch selectable), reduces current to 50% of
setting after one second. Minimum motor inductance is 1 mH.
Run/stop (cw limit), direction (ccw limit), hi/lo speed and enable
inputs are optically isolated, 5-24V logic. 3 - 15 mA input
current. 2200 ohms input impedance. Can be configured for
sinking or sourcing signals.
Recommended external pot/joystick resistance: 1K - 5K .
Joystick dead zone: ± 80 mV.
Potentiometer/analog signal dead zone: 40 mV.
Maurey Instrument Corp., Chicago, IL (773)581-4555
JS31462S5T3 (2 axis) or SAJ2515-F-502 (1 axis)
LO speed range: 0 - 5 rev/sec
HI speed range: 0 - 25 rev/sec
Accel/decel range: 1 to 250 rev/sec/sec
Phototransistor, open collector, open emmiter.
24 volts max, 20 mA max.
100 pulses per motor revolution, 50% duty cycle (square wave).
Mounted on 1/4 inch thick black anodized aluminum heat
transfer chassis. 1.5 x 3.0 x 4.0 inches overall. Power on red
LED. See drawing on page 19 for more information. Ambient
temperature range: 0 - 70 C.
European style screw terminal blocks.
Power Supply & Motor: 6 position. Wire size: AWG 12 - 28.
Signal Input: 10 position. Wire size: AWG 16 - 28.
1/64 step (12,800 s/r) with 1.8 motor. Pure sine waveform.
Complies with EN55011A and EN50082-1(1992).
Technical Specifications