Getting started, 5stm23r hardware manual – Applied Motion STM23R-2ND User Manual
Page 5
Advertising
5
STM23R Hardware Manual
920-0056C
5/5/2015
Getting Started
To get started with your STM23R, you’ll need the following:
• a 12 to 70 volt DC power supply. Please read the section
Choosing a Power Supply
for
help in choosing the right power supply.
• a tool for inserting wires into the connector.
• a source of step signals, such as a PLC or motion controller.
The connectors and other points of interest are illustrated below. These are detailed later in the manual.
Power & Signal
Connector
Mounting holes
DIP switches
(current,
idle current,
steps/rev,
load inertia)
Status LED
Advertising
This manual is related to the following products: