3 installation/connections, 1 connecting the power supply – Applied Motion TXM24IP-1EG User Manual
Page 11
11
Rev. C
920-0089
TXM24 Ethernet Hardware Manual
3 Installation/Connections
To meeting the IP65 protection, a suitable mating connector should be chosen.
For more information, please see the Accessories section.
3.1 Connecting the Power Supply
Use 16 to 20-gauge wire to connect the TXM24 to a power supply. It contains an internal fuse
connected to the “+” terminal that is not user replaceable. If a user serviceable fuse is desired,
install a 6.3 amp fast acting fuse in line with the “+” power supply lead.
Be careful not to reverse the wires. Reversing the connection may open the internal fuse on the
drive and void the warranty.
Power
Signal
Color of mating cable
Phoenix P/N 1431678
Pin no.
V+
BN\BU
1\3
V-
WH\BK
2\4
View of motor side connector
Digital I/O
Power
Ethernet COMM port1
2
3
4
1
J2