Applied Motion TXM24IP-1EG - Manual (Page 19)

19
Rev. C
920-0089
TXM24 Ethernet Hardware Manual
3.4.3 EN Digital Input
While the STEP and DIR inputs are designed for high-speed digital input operation, the Enable
(EN) input is designed for low speed digital input operation between 5 and 24 volts.
Note: If current is flowing into or out of an input, the logic state of that input is low or closed. If no
current is flowing, or the input is not connected, the logic state is high or open.
The diagrams below show how to connect the EN input to various commonly used devices.
5 - 24
volt DC
Power
Supply
Connecting the Input to a Switch or Relay
EN+
EN-
+
-
TXM24 Switch or Relay
(closed = logic low)
5 - 24
volt DC
Power
Supply
Connecting an NPN type Proximity Sensor to an Input
(when prox sensor activates, input goes low)
EN+
EN-
+
-
+
NPN
Proximity
Sensor
-
output
TXM24
5 - 24
volt DC
Power
Supply
Connecting a PNP type Proximity Sensor to an Input
(when prox sensor activates, input goes high)
EN+
EN-
+
-
+
PNP
Proximity
Sensor
-
output
TXM24