Operating heater – Desa LMFP33NR(A) User Manual

Page 22

Advertising
background image

www.desatech.com

111604-01K

22

Setting Room Temperature

Press the up or down key until the small

triangle is to the left of the thermometer icon

(see Figure 38). Press the left or right key to

set the desired room temperature.
Setting Timer (Sleep Function)

Press the up or down key until the small triangle

is to the left of the clock icon (see Figure 38).

Press the left or right key to set the desired

sleep time. Maximum sleep time is 90 minutes,

in 15 minute increments. When desired time is

set, press the up or down key to start the timer.

When the desired time has elapsed, the appli-

ance will automatically switch off.
Child Safety Lock-Out

To lock the remote control keys, press the

On/Off key then immediately press the up key

(see Figure 38). The lock-out function is active

when the lock icon is lit. Repeat key sequence

to unlock keys.
Low Battery Detection and Backup

A battery icon will be displayed on the LCD

display when batteries are low in the remote

control (see Figure 38).

When the receiver detects a low battery

condition;

• Three acoustic “beeps” are generated from

the receiver

• Appliance is turned off and will go to the

maximum flame height

• Execution of commands is inhibited until

batteries are replaced

When batteries are low, it is not possible to

turn on the appliance with the remote control.

Appliance can be turned on or off manually

by setting the backup switch of the receiver to

MAN position (see Figure 35, page 21). Remote

control and receiver will restart normal opera-

tion after batteries are replaced. See Installing

Batteries for Remote Receiver and Hand Held

Remote Control, page 19.
Timeout

If appliance is turned on and no command is

sent to the receiver for 24 hours, appliance will

automatically shut down. Commands sent after

shutdown will be executed normally.

OPERATING HEATER

Continued

HAND-HELD

REMOTE OPERATION

NOTICE: You must light the pilot

before using the hand-held re-

mote control unit. See Lighting

Instructions, page 20.

When the appliance and the remote control

are switched off, the house icon with the room

temperature will be displayed. When the re-

mote control is turned on, other icons will be

visible and the main burner of the appliance

will turn on.

1. Turn control knob clockwise

to the

ON position (see Figure 35, page 21).

2. Press the ON button on remote control

(see Figure 38). Wait 5 seconds to send a

command to appliance.

Note:

An acoustic signal will be heard that

confirms the reception of the command sent

from the remote control.
Setting Flame Height

Press the up or down key until the small triangle

is to the left of large flame icon at the top of

LCD display (see Figure 38). Press the left or

right key to set the desired flame height. Six

flame levels are available from 1 (minimum)

to 6 (maximum).

Left and
Right Keys
Increase and
Decrease
Set Points

On/Off
Button

Flame Height
Indicator

Thermometer
Icon

Clock Icon

Figure 38 - Remote Control

Small Triangle
Icon (Function
Indicator)

LCD Display

Room
Temperature
Display

Sleep Timer
Display

Lock-Out
Indicator

Low Battery
Indicator

Up and Down Keys Moves
Placement from Top to
Bottom on LCD Display

Advertising