Installation – Desa LMFP33NR(A) User Manual

Page 8

Advertising
background image

www.desatech.com

111604-01K

8

INSTALLATION

NOTICE: This heater is intended

for use as supplemental heat.

Use this heater along with your

primary heating system. Do not

install this heater as your pri-

mary heat source. If you have a

central heating system, you may

run system’s circulating blower

while using heater. This will help

circulate the heat throughout the

house. In the event of a power

outage, you can use this heater

as your primary heat source.

WARNING: A qualified ser-

vice person must install fire-

place. Follow all local codes.

WARNING: Never install the

fireplace

• in a bedroom or bathroom

• in a recreational vehicle

• where curtains, furniture,

clothing or other flammable

objects are less than 42 inches

from the front, top or sides of

the heater

• in high traffic areas

• in windy or drafty areas

CAUTION: This fireplace cre-

ates warm air currents. These

currents move heat to wall sur-

faces next to fireplace. Installing

fireplace next to vinyl or cloth

wall coverings or operating

heater where impurities (such

as, but not limited to, tobacco

smoke, aromatic candles, clean-

ing fluids, oil or kerosene lamps,

etc.) in the air exist, may discolor

walls or cause odors.

Note:

Your fireplace is designed to be used in zero

clearance installations. Wall or framing material

can be placed directly against any exterior surface

on the rear, sides or top of your fireplace, except

where standoff spacers are integrally attached. If

standoff spacers are attached to your fireplace,

these spacers can be placed directly against wall

or framing materials.
Use the dimensions shown for rough openings to

create the easiest installation. See Built-In Fire-

place Installation, page 11.
IMPORTANT:

Vent-free heaters add moisture

to the air. Although this is beneficial, installing

fireplace in rooms without enough ventilation

air may cause mildew to form from too much

moisture. See Air for Combustion and Ventilation,

page 5. IMPORTANT: Make sure the fireplace

is level. If fireplace is not level, log set will not

work properly.

CHECK GAS TYPE

Use the correct gas type (natural or propane/LP)

for your fireplace. If your gas supply is not cor-

rect, do not install fireplace. Call dealer where you

bought fireplace for proper type fireplace.

WARNING: This appliance

is equipped for (natural or pro-

pane/LP) gas. Field conversion

is not permitted.

ELECTRICAL HOOKUP

(Models GA3700 Series and GA3700T
Series Blower Accessories and GA3555
Internal Duplex Kit)
This fireplace accepts a blower assembly with an

electrical cord. The electrical cord is five feet in

length. You must locate fireplace within reach of

a 120 volt grounded electrical outlet. If not, you

must install an electrical outlet within reach of

fireplace power cord. The GA3555 outlet acces-

sory is used for built-in applications with blower

accessory installed.

Advertising