Desa VML27PR - Manual (Page 14)

www.desatech.com 111115-01F 14
Figure 13 - Disconnecting Jumper Wire
from Control Valve
Jumper Wire
Control Valve
INSTALLING OpTIONAL REMOTE
CONTROL ACCESSORIES
Installing Remote Receiver
All remote control accessories are available
separately (see Accessories, page 29). The remote
receiver for these accessories will be installed
using the bracket located on the front left side
of the base.
1. Disconnect jumper wire from control valve at
TPTH and TH locations (see Figure 13),
2, Install remote receiver into receiver bracket
using push button clips provided with receiver
(see Figure 14).
3. Connect wires to control valve at the TPTH
and TH locations as shown in Figure 15.
inStALLAtion
Continued
Figure 15 - Connecting Wires
Control
Valve
White
Wire From
Receiver
Red Wire From
Receiver
Figure 14 - Installing Remote Receiver
Remote
Receiver Push Button
Clips
Bracket Battery Clip
9-Volt Battery
Terminal
Wires
Pad
Installing Batteries for Remote Receiver
and Hand-Held Remote Control
Two 9-volt alkaline batteries (not included) are
required to operate this heater with the wireless
hand-held remote control set. One battery must
be installed in the receiver and one in the hand-
held remote control unit. Note: Only use alkaline
batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver behind receiver
bracket mounted on base assembly.
2. Locate the battery clip mounted on the back
of the receiver (see Figure 14).
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to battery. Place battery
into battery housing.
3. Replace battery cover onto remote control
unit.
Figure 16 - Installing Battery in Hand-Held
Remote Control Unit
Battery Cover
9-Volt Battery
Terminal
Wires
Remote Control Unit
Battery
Housing