d&b Z5373 T Cluster bracket - Manual (Page 4)

2. Intended use
The Z5373 T Cluster bracket must only be used in conjunction with d&b
T10 loudspeakers as described in these mounting instructions.
Installation and setup should only be carried out by qualified and
authorized personnel observing the valid national Rules for the
Prevention of Accidents (RPA).
It is the responsibility of the person installing the assembly to ensure that
the suspension/fixing points are suitable for the intended use.
The Z5024 Loudspeaker stand adapter enables the Cluster bracket to
be attached to a loudspeaker stand.
The bracket can be attached on top of maximum one d&b Q-SUB
cabinet using the Z5013 Loudspeaker stand M20 along with the Z5024
Loudspeaker stand adapter.
The bracket can be mounted to overhead bars or trusses with a tube
diameter of up to 51 mm (2") using the Z5010 TV spigot and the
Z5012 Pipe clamp.
3. Safety precautions
General safety
Always carry out a visual and functional inspection of the bracket
before use. In case you have any doubt as to the proper functioning
and safety of the bracket, do not use it. Please also refer to section 8.
Maintenance and care on page 9.
The total center of gravity of the assembly is located at the very top of
the entire assembly.
- Always secure the assembly against movement and possible tipping
over.
- Ensure no person is in the direct area around the assembly.
- When the assembly is mounted to overhead bars or trusses ensure
the secondary safety is applied.
Load safety information
The maximum permitted working load of the bracket is 33 kg (73 lb)
(according to BGV C1) which corresponds to the weight of a maximum
of three T10 loudspeakers.
NOTICE: Always align the bracket vertically when using it, whether
it is suspended or placed on top of a loudspeaker stand.
Right Right WRONG
Observe the maximum permitted load of the additional rigging
accessories as stated in the respective mounting instructions.
Ensure the loudspeaker stand used is designed to safely support the top
load of 37 kg (81.5 lb).
Z5373 Mounting instructions (1.0 EN) Page 4 of 10