d&b Z5373 T Cluster bracket - Manual (Page 5)

4. Total vertical aiming
Depending on the type of application (deployed on a hi stand or
suspended) the bracket can be attached in two directions allowing the
vertical aiming of the entire assembly within a range of 105° (+15° to
-90° or +90° to -15°).
5. Preparations
T10 cabinets
Altering the HF dispersion on T10 cabinets
Fig. 3: Rotating the horn
(shown without front grill for better illustration)
When setting up T-Series arrays and ground stacks set the T10 cabinets
to line source mode.
Swapping between point and line source setups is performed by simply
rotating the horn by 90°. The horn is easily accessible from outside of
the cabinet and can be rotated without any tools or removal of the
front grill.
This is achieved through apertures on the cabinet sides by a mechanism
that provides detents at both the line and point source positions.
The line source mode is indicated by a label on the horn marked with
LINE as shown in the picture below.
Z5373 Mounting instructions (1.0 EN) Page 5 of 10