d&b Z5374 Ti Flyingadapter - Manual (Page 4)

3. Suspension of the Flying bar/array
Dual pickpoint operation and vertical aiming
- For "Dual pickpoint operation", attach the lifting devices to the two
outer pick points of the Flying bar.
- Attach the Pullback anchor device to the bottom cabinet of the array
to permit vertical aiming of the array. (Refer to the following section
4. Setup of the assembly, step 5. Attach the Pullback anchor device
to the bottom cabinet on page 7)
Single pickpoint operation and vertical aiming
- For "Single pickpoint operation", attach the lifting device to the
center bar of the Flying bar.
The selected hole position defines the vertical aiming of the entire
array using the array's center of gravity.
- To achieve more downtilt than is available when using only the
array's center of gravity, attach the Pullback anchor device to the
bottom cabinet of the array. (Refer to the following section 4. Setup
of the assembly, step 5. Attach the Pullback anchor device to the
bottom cabinet on page 7)
Single pickpoint operation using the d&b Z5147 Rota
clamp
Alternatively, the d&b Z5147 Rota clamp can be used to allow the
Flying bar to be mounted to overhead bars and trusses with a tube
diameter of up to 51 mm (2").
For further information and intended use of the d&b Z5147 Rota clamp,
please refer to the respective mounting instructions.
Z5374 Rigging manual (1.0 EN) Page 4 of 10