d&b Z5374 Ti Flyingadapter - Manual (Page 5)

4. Setup of the assembly
Preparations
- Prepare the cables and link cables according to the number of
amplifier channels and cabinets used.
- Ensure the HF sections of the Ti10L cabinets to be used are set to
Line source.
Tools required
Torque wrench with Torx nut #T25.
1. Prepare the first cabinet
To attach the Flying bar to the first cabinet, remove the cabinet's Splay
link on the rear rigging strand. Proceed as follows:
- Release the two Locking pins and fold out the Splay link.
- Remove the circlip of the Splay link's fixing bolt.
- Remove the fixing bolt and take out the Splay link.
2. Attach the Flying bar to the first cabinet
- Attach the Flying bar to the rear rigging strand as shown in the
picture opposite.
- Insert the fixing bolt together with the steel wire of the first Locking
pin assembly.
- Attach the second Locking pin assembly.
Z5374 Rigging manual (1.0 EN) Page 5 of 10