Future Automation SPS - Manual (Page 10)


In
st
al
la
ti
o
n
:
S
ta
ge
5
Page 9 of 28 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
Before fixing the mechanisms, it is a good idea to cut a piece of wood to the size
that you have just measured to provide the correct height. You can then sit both
the mechanisms on the block of wood, knowing they should be the same height as
long as the floor is level.
Fitting The Moving Panel Mechanism
Be sure to fix in the centre of the fixing slots
to allow for adjustments at a later stage, use
washers with screws.
Make sure to use the appropriate fixing type
for the material you will be fixing to.
Make sure the mechanisms
are level and parallel with
each other before continuing.
MDF block to help
with installation
SPS SPLIT V & H - Sliding Panel System Split Vertical & Horizontal