Future Automation SPS - Manual (Page 22)

In
st
al
la
ti
o
n
:
S
ta
ge
1
5
Page 21 of 28 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
Fitting the Screen
To return the mechanism from service mode to user mode, press ‘A’ repeatedly
on the remote to pulse the frame work back in. Once the mechanism won’t go
back any further, wait for two seconds, and the mechanism is then in user mode.
In order to fit the screen, the mechanism must be extended to its full reach. Press
‘OUT’ on the remote control and wait for the Screen Advance mechanism to
reach its pre-set out position.
Once out, press ‘B’ on the remote control repeatedly to pulse the mechanism out
until the frame is extended fully. The mechanism is now in a service mode.
Once extended, the frame can be manually pulled out further, so that the screen
with uprights can be bolted to the frame.
Once the screen is bolted to
the frame, the position of the
screen may require some finer
adjustment.
Adjustments can be made by
altering the height the screen
is fixed to the upright slot detail
or on the SA bracket adjust the
top bolt heads on the screen
mount plate to adjust the level
and height.
If more adjustment is still
needed, remove the screen
and make adjustments to the
PS bracket adjusters, as
shown earlier.
SPS SPLIT V & H - Sliding Panel System Split Vertical & Horizontal