Ilumicon, Ilumicode addresser, Installation – ILUMINARC Ilumipod™ 18g2 IP User Manual

Page 14

Advertising
background image

Installation

10

Ilumipod 18g2 IP Optic RGB User Manual (Rev. 2)





























To assign
individual DMX
addresses to each
product, you must

connect the ILUMICODE
ADDRESSER to each
product, individually.

ILUMINARC®
suggests that you
connect no more
than 20 products

in this mode and keep the
total distance to less than
60 m (197 ft). Otherwise,
you might need to use an
optically isolated signal
amplifier.


ILUMICON

The Ilumipod 18g2 IP Optic RGB can also work with the ILUMICON controller instead
of a standard DMX controller. Please refer to the ILUMICON User Manual to learn how
to use this controller with the Ilumipod 18g2 IP Optic RGB.

The figure below illustrates how to connect the ILUMICON controller to the Ilumipod
18g2 IP Optic RGB.
























ILUMICODE ADDRESSER

The Ilumipod 18g2 IP Optic RGB uses the ILUMICODE ADDRESSER (“Ilumicode”)
for configuration purposes. The diagram below shows how to connect the Ilumicode to
this product. This connection will control multiple products at the same time, all having
the same DMX address.

Important: The Ilumicode must be used to configure this product. The Ilumicode
can be purchased separately through your ILUMINARC® sales representative.

























Advertising