Safety notes, Personal safety, Mounting and installation – ILUMINARC Ilumipod™ 18g2 IP User Manual

Page 6: Power and wiring, Operation, Introduction

Advertising
background image

Introduction

2

Ilumipod 18g2 IP Optic RGB User Manual (Rev. 2)




There are no
user-serviceable
parts inside this

product. Any reference to
servicing you may find in
this User Manual will only
apply to properly certified
ILUMINARC

®

technicians. Do not open
the housing or attempt
any repairs unless you
are certified to do so.




Please refer to
all applicable

local codes and
regulations for the proper
installation of this product.





Keep this
manual for
future

consultation. If you sell
this product to another
user, make sure that they
also receive this manual.




In the unlikely
event that your

Ilumipod 18g2 IP Optic
RGB may require service,
please contact
ILUMINARC

®

Technical

Support.

Safety Notes

Please read all the following Safety Notes carefully because they include important information
on how to install, use, and maintain this product safely.

Personal Safety

· Avoid direct eye exposure to the light source while the product is on.
· Always disconnect this product from its power source before servicing.
· Always connect this product to a grounded circuit to avoid the risk of electrocution.
· Do not touch this product’s housing when operating because it may be very hot.

Mounting and Installation

· This product is for outdoor use and can be submerged (IP67). However, do not

submerge deeper than 1 m for more than thirty (30) minutes.

· CAUTION: When transferring product from extreme temperature environments, (e.g.

cold truck to warm humid ballroom) condensation may form on the internal electronics
of the product. To avoid causing a failure, allow product to fully acclimate to the
surrounding environment before connecting it to power.

· This product weighs 11.6 lbs (5.26 kg). Always ask for help when mounting this

product to avoid personal injuries or damage to the product.

· Make sure there are no flammable materials close to this product while it is operating.
· When hanging this product, always secure it to a fastening device using a safety cable.

Power and Wiring

· Always make sure that you are connecting this product to the proper voltage, as per the

specifications in this manual or on the product’s sticker.

· Never connect this product to a dimmer pack.
· Make sure that the power input cable is not cracked, crimped, or damaged.
· Never disconnect this product by pulling or tugging on the power input cable.

Operation

· The maximum ambient temperature is 113° F (45° C). Do not operate this product at a

higher temperature.

· In case of a serious operating problem, stop using this product immediately!

Advertising