KBC Networks Mesh2HT - Manual (Page 22)

Mesh2HT User Manual
Manual-MESH2HT-Rev1311
Copyright © KBC Networks 2012
Page 22 of 59 www.kbcnetworks.com
2.3.2.2 Mounting Kit Procedure
• Remove all packaging material
• All parts are pre-assembled and ready for mounting. For more fine-tuned alignment,
see next step. Otherwise skip to bullet point 4 below.
• Up/Down Alignment offers one position when using the pre-fabricated channel lock
grooves on parts B and C. Directional antennas may require additional up/down
alignment angles than are allowed on the pre-fabricated grooves. To achieve different
angles, remove the bolt which connects parts B & C and separate. Insert the longer
bolt through part B and add star washer. Re-connect part C and tighten.
• Remove U-Bolt and attach to the pole/mast, re-attach washers and nuts for secure
tight mount positioning.
• Attach Mesh2HT to part C using screw and lock washer
• If using the omni-directional antennas no further mounting steps are needed. If also
mounting directional antennas, use procedure as noted under section 4.1.1.2
• When in the best position tighten all mounts for protection against anything that can
knock the antennas/Mesh2HT out of desired positioning.
2.3.3 Strain Relief Assembly
• Insert A into the large tightening knob (B)
• Thread piece C to the end of A. Do not tighten completely until connected to the
Mesh2HT LAN port and power is confirmed.
• Insert the rubber grommet (D) into the open end of C
• Attach E to threaded portion of C. As E is tightened, the grommet will squeeze against
the Ethernet cable jacket. Leave E loose enough for the cable to wiggle slightly.
Item Qty Description
A 1 Mounting Base
B 1 Left/Right Swivel Bracket
C 1 Up/Down Swivel Bracket &
Mesh2HT Mounting Platform
1 1 U-bolt
2 1 Mast Clamp
3 1 2” Phillips Hex Head 8x30 Screw
4 1 Lock Washer
5 1 1.5” Hex Head 8x30 Bolt
6 1 Star Washer
7 3 Flat Washer
8 3 Hex Nut
9 1 1/4” Lock Washer
10 1 1/4”-20 Phillips Pan Head Screw
A B C D E