KBC Networks ESUL5P - Manual (Page 7)

Ethernet Switch User Manual
Manual-ESUL5P_Series_HW-Rev1112
Copyright © KBC Networks Ltd.
Page 7 of 14 www.kbcnetworks.com
2.3 Installation Method
2.3.1 DIN Rail Mount
• Remove all packaging material.
• Attach the device to a DIN rail.
• Attach copper cables as required.
• Insert the male power block (attached to the supplied in-line PSU) to the
female power socket on the device and tighten the terminal locking screws
using a flathead screw driver.
See Section 2.7 for LED status.
2.3.2 Wall-mount
• Remove all packaging material.
• Unscrew the DIN rail mounting plate from the switch taking special care to
retain the 3 screws using a Phillips No.1 or No.2 screwdriver.
• Attach the supplied wall mount plates to the switch using the screws that
have just been removed from the DIN rail mounting plate with a Phillips
No.1 or No.2 screwdriver.
• Position the unit on the required, flat surface and secure with screws via the
mounting plate holes. Screws are not provided.
• Attach copper cables as required.
• Insert the male power block (attached to the supplied in-line PSU) to the
female power socket on the device and tighten the terminal locking screws
using a flathead screw driver.
See Section 2.7 for LED status.
2.4 Ethernet RJ45 Connections
Each RJ45 port is adaptive and supports auto MDI/MDI-X connection. They can be
connected by straight through or cross-over cables to terminal devices, servers, hubs or
other switches. Each switch supports IEEE802.3x so the optimum transmission mode
(either half-duplex or full-duplex) and data rate (either 10Mbps or 100Mbps) will be
selected automatically.