KBC Networks EE2CL User Manual

Page 10

Advertising
background image

Extended Ethernet User Manual

Manual-EE2CL_Series-Rev1304.docx
Copyright © KBC Networks Ltd. 2013

Page 10 of 19

www.kbcnetworks.com

Joining EE2CL units

•

Remove all the packaging materials and labels.

•

Choose an EE2CL unit (unit ‘A’); this can be any of the units purchased.

•

Using a coaxial jumper lead, connect the chosen EE2CL unit (unit ‘A’) to one
of the other units (unit ‘B’) by attaching one EE2CL unit to each end of the
coaxial cable.

•

Connect the 48Vdc power supply to the EE2CL unit ‘A’.

•

Check that the blue LEDs on both EE2CL units are lit.

•

Wait 20 seconds. Check that the green BNC LEDs on both EE2CL are ‘off’.

Note:

If either of the green BNC LEDs remains ‘on’ then that unit has already been

‘joined’ to another EE2CL unit in a different group and will need to be ‘un-joined’ before
being ‘joined’ to the new unit. See the ‘un-joining’ instructions below.

•

On the EE2CL unit ‘A’ (which is connected to the PSU) use the straightened
paper-clip to depress the push button for 2 seconds. This button can be
found slightly above the PoE LED.












•

The blue Power LED will flash.

•

Depress the same push-button on the EE2CL unit ‘B’ for 2 seconds.

•

Wait for 10 seconds. The two units will now try to establish an encrypted
communication.

•

Once the blue Power LEDs return to a steady condition the units have been
joined.

•

If more EE2CL units need to be ‘joined’, disconnect EE2CL unit ‘B’ from
EE2CL unit ‘A’. Connect the new ‘un-joined’ EE2CL unit ‘C’ to EE2CL unit ‘A’.

•

Repeat the joining instructions until all units in the group are ‘joined’ to the
EE2CL unit ‘A’.

Un-joining EE2CL units

•

Disconnect the EE2CL unit from the old network.

•

Connect a 48vdc PSU to the unit.

•

Wait until the green BNC LED lights.

•

Using the straightened paper-clip press the small push-button located
behind and slightly above the RJ45 LED.

•

Wait until the blue LED turns off.

•

Release the paper-clip.

•

The green BNC and RJ45 LEDs will flash and then turn off.

•

The green BNC LED will then switch on for 10 seconds and then switch off.

•

The units are now un-joined.

Advertising