Knox Video Chameleon64i - Manual (Page 12)

KNOX VIDEO
Chameleon64i Routing Switchers KNOX VIDEO
Chameleon64i Routing Switchers
Page 21 Page 22
HELP COMMAND:
The Chameleon64i CPU responds to the command:
H(ENTER)
by listing the strings available in the command protocol.
The typical terminal readout is:
KNOX Chameleon64i COMMANDS (FOLLOWED BY <CR>:
Bxy/Bxxyy/Bxxxyyy
Both, xx=output yy=input
Vxy/Vxxyy/Vxxxyyy Video, xx=output yy=input
Axy/Axxyy/Axxxyyy Audio, xx=output yy=input
Exy/Exxyy/Exxxyyy Both, delayed xx=output yy=input yy=audio in
Fxy/Fxxyy/Fxxxyyyzzz Video, delayed xx=output yy=input
Gxy/Gxxyy/Gxxxyyy Audio, delayed xx=output yy=input
Jxy/Jxxyy/Jxxxyyy Both, conference xx=out yy=input
Kxy/Kxxyy/Kxxxyyy Video, conference xx=out yy=input
Lxy/Lxxyy/Lxxxyyy Audio, conference xx=out yy=input
Xxyz/Xxxyyzz/Xxxxyyyzzz Both, salvo xx=1st output yy=last output zz=input
Yxyz/Yxxyyzz/Yxxxyyyzzz Video, salvo xx=1st output yy=last output
zz=input
Zxyz/Zxxyyzz/Zxxxyyyzzz Audio, salvo xx=1st output yy=last output
zz=input
Dxy/Dxxyy/Dxxxyyy Dump configuration output xx to yy
Qxyz/Qxxyyzz/Qxxxyyyzzz Both, xx=output yy=video in zz=audio in
M Dump all configuration
W List cards in chassis
Sn/Snn/Snnn Store existing config into map nn (1 - 10)
Rn/Rnn/Rnnn Restore map nn into existing config
Ts/Tss/Tsss Timed sequence, from map 1 every ss sec
N Stop timed sequence
I Send signon message
C Clears arrays
Ups Set port (p=1-4) speed (1=1.2 2=2.4 3=9.6
4=19.2)
H Help (see Help Command Table next page)
The command:
$H(ENTER)
lists the strings available to control volume, tone, and balance. The typical terminal
readout is:
VTB COMMANDS (FOLLOWED BY <CR>):
xx is output number, yy is input number, zz is a value:
$Vxxzz, $Vxx+, $Vxx- Volume (zz=0-63, nom 4)
$Mxx1, $Mxx0 Mute or unmute
$Lxx1, $Lxx0 Loudness on/off
$Bxxzz, $Bxx+, $Bxx- Bass boost/trim (zz=+7 to -7)
$Txxzz, $Txx+, $Txx- Treble boost/trim (zz=+7 to -7)
$Sxx+, $Sxx-, $Sxx0 Balance
$Iyy0, $Iyy+, $Iyy- Input trim
$Dxx Dump output
$DI Dump Trim
$C, $Cxx, $CI, $CIxx Clear
$Fxxzz0, $Fxxzz1 Fade in zz seconds
$H Help for VTB commands