NeoPro Tahoe-Veo - Manual (Page 20)

20
Adding Output Cards
Overview
Adding more outputs to the system can be done by adding one or more Cat5 16
output cards. The following instructions will take you step by step through the
process.
Tip: An ESD (Electro Static
Discharge) wrist strap will be
included with any output cards
that are shipped separate. Wear
it to prevent damage to the
circuit cards.
Opening the System
1) Remove all AC power from the system, and disconnect all signal
cables.
2) Remove the system from the rack.
3) Remove the 7 screws from the rear flange of the top cover.
4) Remove the 4 side screws from the top cover (2 on each side).
5) Slide the top cover back, and then off of the system chassis.
6) Remove 2 screws and slot blank cover from the rear panel. Save the
screws for later. The blank cover can be discarded.