Paxton Superchargers Dodge SRT-10 Ram User Manual
Page 12
1-4
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2))
*** NOTE ***
It is recommended that you measure the length of the
dowel pin and the drill fixture and mark the drill bit for
quick reference.
L.
Drill one hole, rotate the fixture 180° and
drill the second hole.
M.
Remove the drill fixture and confirm depth
of the drilled hole.
N.
After both dowel pin holes have been
drilled, ream the holes to size using the sup-
plied reamer.
O.
Install the supplied dowel pins. Confirm that
the dowel pins are flush with the surface of
the damper.
P.
Reinstall the factory damper bolt and torque
to factory specs.
Q.
Reinstall the radiator in the reverse order of
its removal. Install the coolant hoses and
refill the radiator with coolant.
J.
Install the supplied guide fixture using two
of the factory pulley retaining bolts.
K.
Using the supplied drill bit and with the drill
fixture installed drill through the damper in
to the end of the crankshaft.
Fig.1-j