Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 25)

7-1
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2)
B. Locate the charge air support bracket and
install it on two of the exhaust shield mount-
ing bolts. Install the supplied foam padding
onto the support bracket. (See Fig. 7-b.)
C. Install the 3" silicone sleeves and clamps to
the inlet and discharge of the charge air
cooler.
D. Install the compressor bypass valve with the
gasket and fastener provided (See Fig. 7-c.)
E. Install the compressor bypass filter to the
Section 7
CHARGE AIR COOLER ASSEMBLY INSTALLATION
A. Locate the Charge Air Cooler. Install the 90°
x 1/2"NPT x 3/4" barbed fittings in the
charge cooler. Use teflon paste on these fit-
tings to prevent leakage. (See Fig. 7-a.)
7.1 CHARGE AIR COOLER
INSTALLATION
Fig. 7-a
F. Install the charge cooler to the discharge of
the supercharger. Tighten the hose clamps.
G. Install the discharge duct “A” (Viper Head)
to the Charge Air Cooler outlet and secure
with the hose clamp previously installed.
H. Attach the 4.5" sleeve to the throttle body.
Using two #67 clamps, secure the discharge
tube “B” onto the throttle body. Install the
factory air intake temperature sensor into
discharge tube “B”.
I. Check discharge ducts for proper fitment
and recheck all hose clamps.
Fig. 7-c
Fig. 7-d
Fig. 7-b
bypass valve. You will need to move the
A.C. line to gain clearance for the charge
cooler bypass valve.