Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 13)

2-1
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2)
Section 2
OIL FEED AND ASSEMBLY
A. Locate the oil-sending unit on the passen-
ger’s side of the vehicle. Remove the send-
ing unit connector. (See Fig. 2-a.)
Fig. 2-a
Fig. 2-b
2.1 SUPERCHARGER OIL FEED
INSTALLATION
Fig. 2-c
*** NOTE ***
It maybe easier to install this fitting from the top of the
engine compartment. With the alternator out of the way
it is a straight shot to the top of the fitting installed in
an earlier step.
B. Using a 1-1/8" socket, remove the sending
unit and set aside to be reinstalled in a later
step.
C. Locate the nylon-retaining clip located just
above the factory-sending unit that secures
the factory oil sending sensor wire. This clip
will have to be removed to gain clearance
for the 1/8" x –4 fitting. (See Fig. 2-b.)
D. Install the street TEE in the same location as
the factory-sending unit. (See Fig. 2-b.)
E. Install the straight 1/8" x –4 JIC fitting (sup-
plied in assembly 4PCS130-026) into the
outlet facing toward the top of the engine.
F. Re-Install the Factory oil-sending unit. (See
Fig. 2-c.)
*** NOTE ***
It is not recommended to use anything other than
engine oil on the threads. If Teflon paste or tape is
used, a piece could be dislodged and pass through the
oil feed jet clogging the oil feed jet. This will cause
severe damage to the supercharger.
OIL SENDING UNIT
CONNECTOR
NYLON RETAINING CLIP
TO BE REMOVED