Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 21)

6-1
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2)
Section 6
AIR INTAKE ASSEMBLY INSTALLATION
A. Locate air intake assembly 4PCS212-010
(4PCS212-018 if polished).
B. Install the 4" sleeve and two #64 hose
clamps to the inlet of the supercharger leav-
ing the clamps loose. They will be tightened
in a later step.
C. Locate the 4" cast duct and 3/8"NPT x 1/2"
x 90° barbed fitting.
D. Install the fitting into the cast duct using a
small amount of teflon sealant. (See Fig.
6-a.)
6.1 AIR INTAKE DUCT INSTALLATION
E Install the cast duct into the 4" sleeve previ-
ously installed to the inlet of the supercharg-
er.
F. Orient the barbed fitting so it points to the
passenger’s side valve cover. (See Fig. 6–b.)
G. Attach a length of 1/2" fuel hose to the
barbed fitting and route towards the crank
case vent hose located at the front of the
engine. (This vent hose was previously
removed in the disassembly of the factory
air intake system.) (See Fig. 6-c.)
Fig. 6-a
Fig. 6-b
Fig. 6-c
THIS PORTION WILL
NOT BE RE-USED