Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 19)

5-1
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2)
Fig. 5-a
Fig. 5-c
Fig. 5-b
Section 5
SUPERCHARGER ASSEMBLY INSTALLATION
A. Attach the 1/2" oil drain hose to the super-
charger using the hose provided and one #8
hose clamp.
B. Lower the supercharger into place. Guide
the oil drain hose so there are no kinks or
dips in the hose.
C. Loosely install the 3/8-16 counter-sunk bolt
in the supercharger mounting plate (located
just below the tapped hole). Install this spac-
er between the supercharger and the plate.
*** NOTE ***
This bolt must be installed before the Idler pulley is
installed. (See Fig. 5-a.)
5.1 SUPERCHARGER INSTALLATION
E. When all of the supercharger mounting bolts
are installed, evenly tighten all supercharger
mounting bolts.
F. Using one #8 hose clamp, attach the oil
drain hose to the 1/2" barbed fitting that was
installed in Section 3 (oil drain installation).
G. Install the 90° x 1/4" x –4 fitting into the
supercharger oil feed jet. Use only oil on
this fitting rather then teflon paste or teflon
tape. Either of which may become dislodged
and enter the jet clogging the small orifice
of the oil feed jet. Attach the 22" long –4
stainless steel braided hose installed in an
earlier step. (See Fig. 5-c.)
D. Install the two supercharger mounting bolts
with their spacers in the outer most mount-
ing holes of the supercharger mounting
plate. Loosely tighten these bolts. (See Fig.
5-b.)
SUPERCHARGER
MOUNTING BOLT HOLES
COUNTER SUNK
BOLT LOCATION