Signamax 10/100 to 100FX Industrial DIN-Rail Mount Компьютерные Аксессуары - Manual (Page 5)

065-1800 series Hardened Media Converter
User’s Manual 5
One-Channel Media Converter
Ports
The Signamax 065-1800 series Hardened Media Converter provides one TX
port and one FX port. For the FX port, it provides options of:
Multimode fiber using SC, ST, VF-45, MT-RJ or LC connector, or
Singlemode fiber using SC or ST connector, or
WDM fiber using single SC connector
For the TX port, it uses an RJ-45 connector, auto-MDIX, and auto-
negotiates 10/100 Mbps speed and full-duplex or half-duplex modes.
Port Settings
Port settings are made easily by means of a DIP (Dual Inline Package)
switch at the front panel of the harden media converter.
Default DIP switch settings:
DIP switch
There are six pins on the DIP switch for port settings. Refer to the table below for more
details.
DIP switch No. 0 1
1 Disable Link Fault Signaling Enable Link Fault Signaling
2 Enable auto-negotiation for TX
port Enable forced mode for TX
port
3 TX port forced to 100 Mbps TX port forced to 10 Mbps
4 TX port forced to full duplex
mode TX port forced to half duplex
mode
5 FX port forced to full duplex
mode FX port forced to half duplex
mode
6 Disable link down alarm Enable link down alarm
First, disconnect the converter from the power. Then toggle Pin 2 of the DIP switch to
position 1 to enable the forced mode for TX port.
<NOTE> Pin 2 must be toggled to position 1 prior to manually setting speed and
duplex mode.
Toggle Pin 3 to position 0 to force the TX port to the speed of 100 Mbps, or toggle Pin
3 to position 1 for 10 Mbps speed.
Toggle Pin 4 to position 0 to force the TX port to full duplex mode, or toggle Pin 4 to
position 1 for half duplex mode.
Toggle Pin 5 to position 0 to force the FX port to full duplex mode, or toggle Pin 5 to
position 1 for half duplex mode.
Toggle Pin 1 to position 0 to disable Link Fault Signaling (LFS).
1 2 3 4 5 6 1
0