Televes Coaxdata 1Gbps-HDTV COAX+PLC 1ETH+1SFP - Manual (Page 10)

CoaxData 1Gbps-HDTV Ref.769201/Ref.769202
10
Setting Modem operating mode
Operating mode can be set by CoaxManager
™
management/control features. CoaxDATA Modem has
two operating modes depending on the type of network you want to create:
 Home Networking: This operation mode is set at
the factory and allows the creation of a local area
network where all devices communicate with each
other. These networks are usually created when
the modem is used to extend internet services
within a house. This mode is Modem defaults and
can be set anytime pressing Defaults button on the
front of device.
 MDU/MTU (Multi-Dwelling/Multi-Tenant Unit).
This mode uses existent coaxial network on
building or house from the headend to
communicate with coax outlets and provide access
to multiple dwellings avoiding communicate with
each other. In this mode have two elements:
• MDU Master : Typically installed at the distribution headend, manages all network
elements and can be plugged to an ADSL modem or any other device provided by
ISP (Internet Service Provider) to connect to the Internet.
• MDU Slave: Installed in each of coax outlets provides the access points for user
data.
These operating modes are set by CoaxManager Software.
In the Configuration
tab, you can set
whether or not to
enable the MDU and if
mode of operation is
master or slave.
You can also indicate
transmission medium
the connection is
made, only coaxial or
hybrid
network
(Coaxial + Electrical).
EN
www.televes.es