Televes Coaxdata 1Gbps-HDTV COAX+PLC 1ETH+1SFP - Manual (Page 14)

CoaxData 1Gbps-HDTV Ref.769201/Ref.769202
14
Connect Slave to Coaxial Outlets
Following instructions show how to connect CoaxData 1Gbps HDTV from your PC to coaxial socket.
Once installed you can connect directly to the network interface of your PC without any drivers or
software:
 Select Operating mode Master/Slave : Operating mode Master / Slave: To create data network it
is necessary that one of the modems operate in master mode, which will be installed at the head,
the rest of the modems will be installed in the sockets and must be configured in slave mode by
CoaxManager.
 Connect Modem to PC : CoaxData 1Gbps-HDTV is equipped with two connectors that support
Ethernet 1000/100/10 Mbps speeds with auto-negotiation enabled, which allows to reach the
maximum possible speed, and incorporates MDI-X function which avoids the use crossover
cables.
• Connect one end of the Ethernet cable to an CoaxDATA Ethernet port.
• Connect the other end to an PC or laptop Ethernet port.
EN
www.televes.es