Top Global MB8000 - Manual (Page 18)

Top Global USA. ----MB8000 User Guide
- 17 -
space applicable to the PDP.
z AT Command: This parameter is used to initialize modem with some AT
commands.
2. If wireless card type is absent, page shown to users likes Figure 3-5.
Figure 3- 5 No card
3.3.2.2 Local IP Configuration
IP Configuration
z Local IP Address: This parameter represents the IP Address of the LAN & WLAN.
The default IP address is 172.16.0.1.
z Local IP Mask: This parameter represents the subnet mask of the LAN & WLAN.
The default subnet mask is 255.255.0.0.
DHCP Server
z DHCP Server Status: This parameter indicates whether the DHCP server is
enabled or disabled in MB8000. If DHCP is disabled, each client device must be
manually configured.
z Start IP Address: The start IP address for the DHCP IP address pool.
z Width of IP Address: The DHCP IP address pool range.
z Default Lease Time: The default lease time in seconds for the IP address
assigned by the DHCP server to the DHCP client.
z Maximum Lease Time: The maximum lease time in seconds for the IP address
assigned by the DHCP server to the DHCP client.
DNS Configure
DNS Relay, also called DNS Redirect or DNS Proxy, allows clients on the local network to
use the gateway as their primary DNS server. In this way, all DNS queries from clients are
sent to MB8000 and then automatically forwarded to your ISP's DNS servers by MB8000.
This allows clients to always be able to use the gateway as their DNS server regardless of
changes in DNS server that your ISP may make in the future.
z DNS Relay Status: This parameter indicates whether DNS relay is enabled or
disabled.