Top Global MB8000 - Manual (Page 23)

Top Global USA. ----MB8000 User Guide
- 22 -
Pre-Shared Key to authenticate the users. To use WPA PSK mode, you should configure
MB8000 as following:
1. Set "Network Authentication" to "WPA-PSK";
2. Set "Data Encryption" to "TKIP";
3. Set "Deny Non-Encryption Data" to "Disable";
4. Set "WPA Pre-Shared Key" with a pass-phrase (min 8 max 63 characters);
z Data Encryption:
This parameter sets the data encryption type.
“Disabled” means that no encryption is used in the traffic between the MB8000 and the
stations.
“WEP” means that the traffic data is encrypted by WEP.
“TKIP” means that TKIP is used in the traffic.
z Key length: There are two options you can select to decide the WEP key length.
z Encryption Key: These parameters are used as WEP keys.
z Deny Non-Encrypted Data: Select Enable to prevent use of non encrypted data, or
select Disable to allow non-encrypted data.
z Encrypt Data Transmissions Using: Indicates which WEP key ID is selected to
encrypt the outgoing data.
z 802.1x Re-Authentication Interval:
The 802.1x Re-Authentication Interval field is an integer, which indicates that how
long the 802.1x authenticator will issue a re-authentication request in second. The
minimal is 600, and the default value is 600.
Note:
The range of this value is from 600 to 65535.
z WPA Group Key Renewal:
This field is an integer, which indicates that the interval of TKIP key to
renew. The minimal is 300.
z WPA Pre-Shared Key (passphrase):
The WPA Pre-Shared Key field, which is to be filled with WPA-PSK, it’s a string of
“pass-phrase”, whose length ranges from 8 to 64 octets.