Vectronics VEC-830K - Manual (Page 10)

VEC-830K Instruction Manual Single Side-Band Filter
7. Insert R4 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
8. Locate resistor R5. This is a 150K ohm resistor (brown-green-yellow-
gold).
9. Insert R5 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
10. Locate resistor R6. This is a 240K ohm resistor (red-yellow-vellow-
gold).
11. Insert R6 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
12. Locate resistor R7. This is a 240K ohm resistor (red-yellow-yellow-
gold).
13. Insert R7 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
14. Locate resistor R8. This is a 1.2M ohm resistor (brown-red-greengold).
15. Insert R8 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
16. Locate resistor R9. This is a 1.2M ohm resistor (brown-red-greengold).
17. Insert R9 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
18. Locate capacitor Cl (1000pF). This is a polystyrene capacitor and will
be marked "10001" (actual value in pF). Carefully install C1, solder
in place, and trim the leads.
19. Locate capacitor C2 (1000pF). This is another polystyrene capacitor
and will be marked "10001" (actual value in pF). Carefully install C2
in the same manner as C1, solder in place, and trim the leads.
20. Locate capacitor C3 (1000pF). This is another polystyrene capacitor
and will be marked "10001" (actual value in pF). Carefully install C3
in the same manner as C2, solder in place, and trim the leads.