Vectronics VEC-830K User Manual
Page 13
1
V
EC-830K Instruction Manual
Single Side-Band Filter
48. Connect wire located at Point #4 to Point A on SW1. Solder in
place and trim the lead.
49. Locate capacitor C9 (IOuF). This is an electrolytic type capacitor
and will be marked "lOuF" with an arrow pointing to the negative end.
50. Trim the positive lead of C9 so about only 3/8" of the lead remains.
51. Connect the positive lead of C9 at Point B on SW1.
Do not
solder this switch contact vet.
52. Locate one (1) 6" insulated wire and cut it in half, making two (2)
3" wires.
53 Cut one (1) 3" wire in half making two (2) 11/2" pieces.
54 Using the wire strippers, remove about 1/4" of the insulation from
each 1 1/2" pieces of wire.
55. Connect one (1) 1 1/2" piece of wire between Points B and E on
SW1. Solder both ends in place
switch contact.
and trim the excess
lead
from
the
56. Connect wire located at Point #3
to Point C on SW1.
Solder
i
place and trim the lead.
57. Connect wire located at Point #2
to Point D on SW1.
Solder
i
place and trim the lead.
58. Connect wire located at Point #1
to Point F on SW1.
Solder
i
place and trim the lead.