WaveWare Alert Utility - Manual (Page 18)

Step 1 – Configuration – Input Protocols – Plain Text
Step 1 – Plain Text Protocol
Click the “ Configure Input Protocol ” Button to Configure the Plain Text Protocol. See Fig. 20A
Configure Plain Text Protocol with a Data Delimiter and Delimiter Time-out . See Fig. 20B
Fig. 20A - Click “Configure Input Protocol”
Corresponding Configuration for Plain Text Protocol
See Page 39
Fig. 20B
Choose the Data Delimiter, <CR> is Default
Choose Delimiter “Time-Out”, 10 Sec is Default
The Plain Text Protocol Configuration also allows the use of Message Filtering Rules.
Click on the “
Filter Help ” Button to Open the Coding Help Screen, See Fig. 21A
At the top of the Screen you will find “Coding Help” and at the Bottom of the Screen you write the Code for the
Rule you want use. In the “
Candidate Message Filtering Rule ” Field you will see the Written Code and you can
test the Rule by Clicking the “ Test Filter ” Button.
If the Rule is ready, Click the “ Apply Filter ” Button. See Fig. 21B
Fig. 21A
To Configure Filtering Rules Click on “Filter Help”
Fig. 21B
Configure Filter Rules Screen
18