XTA DS8000/D - Manual (Page 15)

Page 15 DS8000 Operator’s Manual
ta x
Finally, the solo bus is directly connected to the headphone amplifier and anything switched
via the front panel “Solo” switches will be mixed onto this bus along with any incoming
signals on the external solo input on the rear panel.
As the monitoring point for the solo signal is before the “O/B Split” switching, enabling a
“Solo” on a channel whilst in “O/B Split” mode will still feed the local channel’s input signal
onto the bus, NOT the signal being derived from the master channel (and being fed to the
local channel’s outputs).
The metering monitor point is post the “O/B Split” switches so meters will always show the
master channel’s signal in split mode.