Zilog S3F80QB - Manual (Page 13)

UM026703-1014 Start the Ledblink Sample Program
S3F80QB Development Kit
User Manual
10
8. After selecting S3FlashIsp from the Debug Tool drop-down menu, click Setup to
select the serial number of the S3 Flash ISP you are using, as indicated in Figure 10.
The serial number you see on your screen will be different from the serial number shown
in Figure 10.
9. Click OK to close the Setup USB Communication dialog box.
10. Click OK to close the Project Settings dialog box.
11. If you are prompted to rebuild any affected files, click Yes . Otherwise, choose Build
from the menu bar, then click Rebuild All . The following message is displayed.
OUTPUT CHECKSUM
ledblink.hex FBD4
ledblink.lod FBD4
0 warning(s)
0 error(s)
Build succeeded.
Figure 10. The Setup USB Communication Dialog
Note: