Adept AdeptSight Reference Guide - Manual (Page 411)

ProjectionMode
VPARAMETER
140
Projection mode used by the tool to detect edges.
Figure: Projection Modes used by Arc Caliper and Arc Edge Caliper
Syntax
MicroV+
VPARAMETER (sequence_id, tool_id, 140, index_id, object_id) = value
value = VPARAMETER (sequence_id, tool_id, 140, index_id, object_id)
V+
VPARAMETER (sequence_id, tool_id, 140, index_id, object_id) $ip = value
value = VPARAMETER ($ip, sequence_id, tool_id, 140, index_id, object_id)
Type
0 or 1
Range
Value Projection Mode Description
0 hsProjectionAnnular
Annular projection is used to find edges that are aligned with the
median annulus, such as arcs on concentric circles.
1 hsProjectionRadial
Radial projection is used to find edges aligned along radial pro-
jections, much like the spokes of a wheel.
ProjectionMode
AdeptSight Reference Guide, v3.2.x, Updated: 5/8/2012
Page 411