Section 3 scpi commands -1, 1 miscellaneous commands -1, 2 measure commands -1 – AMETEK CW Series Programming Manual User Manual
Page 10: Scpi commands, 1 miscellaneous commands, 2 measure commands
Programming Manual
3-1
SECTION 3
SCPI COMMANDS
3.1 Miscellaneous Commands
:ASSYno?
Returns the assembly number.
3.2 MEASURE Commands
:MEASure [phase]
Measurement words, phase 1-3.
:CURRent
Return measured current.
:PEAK?
Return the peak current measured.
:INRUSH?
Return the inrush current measured.
:FREQuency?
Return the frequency measured.
:PEAKCURRent?
Return the peak current measured.
:POWer?
Return presently calculated power in Watts.
:POWer
:TOTAL?
Return presently calculated power in Watts.
:POWERFACtor?
Return the power factor measured.
:POWERFACtor
:TOTAL?
Return the power factor measured.
:CRESTFACtor?
Return the crest factor measured.
:VA?
Return the Volt/Amps measured/calculated.
:VA
Return the Volt/Amps measured/calculated.
:TOTAL?
Return the Volt/Amps measured/calculated.
:VOLTage?
Return the RMS voltage.