AMETEK XHR 1000 Watt Series User Manual

Xhr 1000 watt series programmable dc power supply

Advertising

Table of contents

Document Outline

warning
- warning
05.pdf
- Section 1. Features and Specifications
06.pdf
- Section 2. Installation
  - Basic Setup Procedure
  - Inspection, Cleaning, and Packing
    - Initial Inspection
    - Periodic Cleaning
  - Returning Power Supplies to the Manufacturer
    - Return Material Authorization Policy
    - Packaging for Shipping or Storage
  - Location, Mounting, and Ventilation
    - Rack Mounting
    - Ventilation
  - AC Input Power
    - AC Fail LED
    - AC Input Cord
  - Functional Tests
    - Equipment Required
    - Power-on Check
    - Voltage Mode Operation Check
    - Current Mode Operation Check
    - Front Panel Function Check
  - Load Connection
    - Load Wiring
      - Insulation Rating
      - Current Capacity
      - Load Wiring Length for Operation with Sense Lines
      - Noise and Impedance Effects
    - Making Load Connections
      - Binding Posts (All Models)
      - 7.5 V to 40 V Models
    - Inductive Loads
      - 60 V to 600 V Models
    - Connecting Single Loads
    - Connecting Multiple Loads
      - Parallel Power Distribution
      - Radial Power Distribution Method
  - Local and Remote Sensing
    - Sense Wiring
    - Local Sensing
    - Using Remote Sensing
07.pdf
- Section 3. Local Operation
  - Standard Operation
    - Operating Modes and Automatic Crossover
      - Constant Voltage Mode Operation
      - Constant Current Mode Operation
      - Automatic Mode Crossover
    - Shipped Configuration (Local Control Mode)
    - Setting Output Voltage and Current Limit
  - Using Multiple Supplies
    - Configuring Multiple Supplies for Series Operation
    - Configuring Multiple Supplies for Parallel Operation
      - Sensing for Parallel Operation
    - Configuring Multiple Supplies for Split Supply Operation
      - Two Positive Voltages
      - Positive-negative Supply
  - Using Over Voltage Protection (OVP)
    - Front Panel OVP Operation
    - Resetting the OVP Circuit
  - Using the Shutdown Function
    - STANDBY Switch
    - Controlling the Shutdown Function via the J2 Connector
  - Over Temperature Protection (OTP)
  - User Diagnostics
    - Emergency Shutdown
    - Unusual or Erratic Operation
    - Troubleshooting for Operators
      - Abbreviated References Used in Table
08.pdf
- Section 4. Remote Operation
  - Remote Analog Programming of Output Voltage and Current Limit
    - Remote Programming Options
      - Isolated Programming
      - Remote Digital Programming
    - Remote Analog Programming Procedure
    - Sample Configuration
  - Remote Monitoring of Output Voltage and Current
    - Readback Signals
  - Using the Isolated Programming (ISOL) Interface Option
    - ISOL Specifications
    - ISOL Setup and Operating Instructions
    - ISOL Calibration
09.pdf
- Section 5. Calibration
  - Calibration Setup
    - Service Environment and Precautions
    - Equipment Required
  - Front Panel Calibration
    - Additional Setup
    - Voltmeter Calibration
    - Ammeter Calibration
    - Over Voltage Protection (OVP) Calibration
  - Calibrating for Programming Accuracy
    - Voltage Programming Circuit Calibration
    - Current Programming Circuit Calibration
  - Calibrating for Readback Accuracy
    - Output Voltage Monitor Circuit Calibration
    - Output Current Monitor Circuit Calibration
06-section2.pdf
- Section 2. Installation
07-section3.pdf
- Section 3. Local Operation
08-section4.pdf
- Section 4. Remote Operation
09-section5.pdf
- Section 5. Calibration