Artel DLC156M DLC156D - Manual (Page 4)

www.artel.com | 978-263-5775 | [email protected] | [email protected]
DigiLink Six Channel TDM De-Multiplexer
for 3G, HD, SDI, and ASI [DLC156D ]
DigiLink Six Channel TDM De-Multiplexer
for 3G, HD, SDI, and ASI [DLC156D ]
DLC156D Rear Panel LEDs
LED Function Color Description
OK
DLC156D
Module
Status
OFF If power is applied to the system, an internal fault may exist.
n Green Normal operation
n Yellow Minor alarm
n Red Major alarm
EMS
DigiLink Manager
System
Status
OFF The module’s configuration is controlled by the onboard configuration switches.
n Green
The module’s configuration has been set by DigiLink Manager EMS. When green, the configuration
switches have no effect on the module’s operation.
A, B, C, D,
E, F
(RATE)
Input Rate
OFF No input signal, an SD-SDI input or an ASI input
n Green A HD-SDI signal
n Yellow A 3G-SDI signal
A, B, C, D,
E, F
(STAT)
Input
Status
OFF Channel disabled
n Green Video detected on channel
n Yellow No video detected on channel
n Red Channel contains a signal outside the frequency range (+/- 100 PPM)
 Red 3G-SDI blocked at source (DLC156M)
 Flashing red
DLC156D Front Panel LEDs
LED Function Color Description
OK
DLC156D
Module
Status
OFF If power is applied to the system, an internal fault may exist
n Green Normal operation
n Yellow Minor alarm
n Red Major alarm
EMS
DigiLink Manager
System
Status
OFF The module’s configuration is controlled by the onboard configuration switches.
n Green
The module’s configuration has been set by DigiLink Manager EMS. When green, the configuration
switches have no effect on the module’s operation.
TX
Transmitter
Status
OFF Repeater is disabled, laser is off
n Green Normal repeater operation, TX is enabled
 Red No XFP is installed or a transmitter fault
RX Receiver Status
n Green Normal operation
 Yellow High receive power
 Red No XFP is installed, or invalid input signal exists
RX
ERR
Receiver Errors
OFF No optical errors
 Green Error detected and corrected
 Yellow Error detected and corrected, high error rate warning
n Red Error detected, could not be corrected
A, B, C, D,
E, F
(RATE)
Input Rate
OFF No input signal, an SD-SDI input or an ASI input
n Green A HD-SDI signal
n Yellow A 3G-SDI signal
A, B, C, D,
E, F
(STATUS)
Input
Status
OFF Channel disabled
n Green Video detected on channel
n Yellow No video detected on channel
n Red Channel contains a signal outside the frequency range (+/- 100 PPM)
 Red 3G-SDI blocked at source (DLC156M)
 Flashing green |  Flashing yellow |  Flashing red
AR208-008211-B00_A